[ Huaqiang Security Network News ] 
The camera of the camera is a semiconductor imaging device. Although it is small, it has the advantages of anti-glare, small distortion, long life, high sensitivity, anti-vibration, etc. Image generation is based on the current surveillance camera defense system. CCD cameras, so the safe installation of cameras has become a topic of concern, especially in terms of wiring. How to carry out indoor wiring? Listen to the author's suggestion.
When the camera is installed, the wiring of the conduit is available in both clear and dark configurations. The camera's clear piping requires horizontal and vertical, neat and beautiful. Dark piping requires short, smooth, and elbows. When wiring, try to avoid wires with connectors. Unless the connector is not available, the connector of the camera must be crimped or soldered, and the wire connections and branches should not be mechanically affected. The wires that are empty in the tube must not have a joint under any circumstances. If necessary, place the connector on the junction box probe terminal. The alarm from the camera alarm control box to the ceiling requires management to be installed in the wall or protected by iron pipes to improve the anti-destructive performance of the anti-theft system. In addition, the AC power should be routed separately, the camera cannot be connected to the signal line and the low-voltage DC power line. When worn in the same tube, the AC power cord should be installed in accordance with electrical installation standards. The signal line cannot be parallel to the high-power power line, and it cannot be worn in the same tube. If it is limited by the environment, it should be kept away from the line by 50cm. For the camera cable, the rated voltage should be greater than the working voltage of the line; the insulation of the wire should conform to the installation method of the line and the environmental conditions for laying. The cross-sectional area of ​​the wire should meet the requirements of power supply and mechanical strength.
Through the above steps to install, I believe that everyone will understand, I hope to help everyone.
The industry wash fabric is mainly applied in professional uniform. The application scene covered like fire retardant uniform,forest flame-retardant matching clothing. In oil,coal mine,steel and electricity `s professional clothing, our industry wash fabric has all applied.
For our D6610,D6620,even after 50 times wash, it still has no dropping or gluing.
Availabe using the high ph solvent ,decolorizer,the dry temprature should not over70 ℃. Help tp satisfy the different require for the customer.
Industry Wash Reflective Series,Industrial Washing Reflective Fabric
Daoming Optics & Chemical Co., Ltd , http://www.dmreflective.com