At the same power, the vane motor is smaller, lighter and less expensive than the piston motor. Due to its simplicity of design and manufacture, it can be used in almost all areas. The vane motor operates over a wide range of speeds and torques and is the most widely used gas motor type.
2. Radial (radial) piston air motor
Its speed is lower than that of the vane motor, but it has excellent starting and speed control performance, especially suitable for radial heavy load and low speed. Piston air motors are generally operated horizontally.
3. Reversible/irreversible motor
In the same type, the speed, torque and power of the irreversible air motor are higher than that of the reversible air motor.
4. working pressure
When a gas motor is selected, the performance table indicates a set of performance parameters for the gas at a specific working pressure of 90 psig (620 kPa), and the gas motor is in optimal design at this working pressure. By adjusting the intake and exhaust pressures, the speed, torque and power of the air motor can be adjusted infinitely;
When the air motor is below 40 psig, its performance may not be very stable;
The air motor can operate at operating pressures above 100 psig, but at this point the air motor wear is increased;
A principle can be followed when determining the air motor model: a selection of 70% of the minimum available air pressure allows the selected air motor to have sufficient power to handle the starting shock and possible overload.
5. Maximum power of air motor
The maximum power of the non-restricted speed motor is achieved at 50% of the free speed (no-load speed);
The maximum power of the speed limit motor is achieved at 80% of the free speed (no-load speed).
6. Working speed
The speed limit air motor does not run at no load;
The operating speed of the air motor can be ascertained in its performance curve, and the nominal speed on the nameplate is only a distinction.
7. Working torque
When determining the air motor model, as important as the speed is the operating torque, these two parameters determine the gas motor power. Pay attention to the difference between static (maximum) torque and working torque when selecting.
8. Air motor speed and torque
The starting torque is approximately 75% of the maximum torque;
Working torque (at different speeds) can be found on the motor performance curve or calculated by the following formula;
Torque (pounds, British) = horsepower. 5250 / speed (r / min)
Torque (N.M)=KW.9550/speed (r/min)
9. Radial load on the output shaft of a pneumatic motor
The radial load of the air motor output shaft (defined as the midpoint of the shaft key) should be considered when selecting the air motor. See the motor performance curve.
10. Air system and gas supply
Once the air motor is selected, the air pressure that the system can supply to the motor is important. The system air compressor calibration gas is not equivalent to the air pressure at which the air motor operates. This is due to the possible various losses in the system. The exhaust restriction of the motor also affects its performance.
11. Entrance control
A reversible air motor is installed, and a four-way valve or two three-way valves can be used to exchange the inlet and outlet ports.
12. Replace the electric motor with a pneumatic motor
Except for the DC motor, the characteristic curve of other electric motors is completely different from that of the air motor. Many electric motors allow for an excessively large safety factor for overload (ie, a waste of configuration), while a replacement gas motor can meet the requirements with relatively low power.
Product Name, 8CH HD surveillance Wifi IP camera with NVR Kit Outdoor, Wholesale Home Security Camera System wireless XMR-JK48
Model XMR-JK48
Operating System Embedded Linux OS
AV(audio/video)input Network Video 8CH
Network video input broadbank 72Mbps
AUdio Bitrate 64Kbps
AV (audio/video) output HDMI input 1ch,resolution:1024x768,1366x768,
1440x900,1920x1080p
VGA output 1ch, resolution:1024x768,1366x768,
1440x900,1920x1080p
AV CODEC Specification Video Resolution D1/720P/960P/1080P
synch-playback 8CH
Video Control Video/Capture mode Maual, Time,Motion,Alarm
Playback mode Real time, Routine, Event
Backup USB backup
Alarm Alarm Input 4ch (optional)
Alarm Output 1ch (optional)
Hard Disk Type 1*SATA interface
Max Capacity 4 TB at most for each
External Interface Network Interface 1 adaptable RJ45 10M/100M, 2 WIFI interface
USB Interface 2 USB 2.0
Protocol UPnP (play&plug)/SMTP (email survice)/PPPoE (dial-up)
DHCP (Automatically obtain an IP address), etc-
Network Control
Others Power Supply DC12V 3A
Power Consumption (W) ≤5W(Without HDD)
Operate Temperature (°C) -10℃~+55℃
Working Humidity (%) RH 10%~90%
Size 257mm(W)×210mm(V)×45mm(H)
Weight(excluding HDD) ≤1Kg
IPC Specification
Technical Parameters Model PE3013-W
Sensor 1/4" Progressive Scan Sensor
Signal System PAL/NTSC
Resolution 1280 x 960 16 : 9 High Defination
Minimum illumination Color: 0.1 Lux; B/W: 0.01 Lux
Shutter 1/25s to 1/25,000s
Lens 3.6MM
OSD Date Time & Title
White Balance Auto
Day&Night Auto / Color / BW
3D-DNR Auto
Mirror/Flip On / Off
Frame Specification Three Streaming at the Same Time:
H.264 128x720@30fps or below
H.264 640x480@30fps or below
S/N > 39.1 Db
Interface RJ45 / WIFI 802.11b/g/n
General Specification Anti-thunder Level Standard IEC61000-4-5
Working Temperature/Humidity -10℃ to +50℃ / 30% to 80% RH
Storage Temperature/Humidity -20℃ to +60℃ / 20% to 90% RH
Power Input DC12V-1A
Power consumption ≤6W
Size 205(L)×70(W)×55 (H)mm
Weight 500g
Level of Protection IP66
Surveillance Cameras,Night Vision Surveillance Cameras,Hidden Surveillance Camera,Panoramic Surveillance Camera
Shandong Shinaian Trading Co., Ltd. , http://www.cnpcworld.com