**Bearing Professor Explains the Causes and Solutions for Bearing Overheating**
Home > Bearing Knowledge > Bearing Professor Helps You Analyze the Causes and Disposal Methods of Bearing Overheating
---
*Bearing Network* | *December 7, 2013*
---
Overheating in bearings is a common issue that can lead to serious mechanical failures if not addressed properly. In this article, a bearing expert provides an in-depth analysis of the main causes behind bearing overheating and offers practical solutions to resolve them.
Here are seven key factors that contribute to bearing overheating and how to handle them:
1. **Damaged Bearings**: If the bearing itself is damaged, it should be replaced immediately to prevent further damage to the motor or machinery.
2. **Improper Lubrication**: Too little or too much grease can cause overheating. The grease should not exceed 70% of the bearing's total volume. Additionally, if the grease contains impurities like iron shavings, it must be replaced with clean lubricant.
3. **Incorrect Fit Between Shaft and Bearing**: A tight or loose fit between the shaft and the bearing can lead to excessive friction. If the fit is too tight, the shaft should be ground down slightly. If it’s too loose, the bearing should be securely mounted on the shaft.
4. **Misalignment Between Bearing and End Cap**: If the bearing and end cap do not fit properly, it can cause uneven pressure and heat buildup. When the bearing chamber is too tight, it should be reprocessed. For a loose fit, a steel sleeve can be installed inside the end cover.
5. **Improper Installation of Motor Caps or Bearing Covers**: Incorrect installation of the end caps or bearing covers can result in misalignment. Ensure that these components are fully seated and all screws are tightened properly.
6. **Tension Issues with Belts or Couplings**: A belt that is too tight or a coupling that is not aligned correctly can cause unnecessary stress on the bearings. Adjust the belt tension and check the alignment of the coupling to reduce strain.
7. **Lubrication Problems in Sliding Bearings**: Sliding bearings may overheat due to insufficient oil, contamination, or a stuck oil ring. Refueling with fresh lubricant and repairing or replacing the oil ring can help restore normal operation.
---
**Related Articles:**
- The Use of Imported Bearings in Daily Operations and Technical Energy-Saving Heat Treatment
- SKF Bearing: Types of Ball Bearings and Their Classification
- Expert Tips: Layout and Features of Spherical Roller Bearings
---
**Share this article with friends or leave a comment below.**
Close Window
---
This article is sourced from [China Bearing Network](http://). Please reference the original source when sharing.
Previous: Pre-treatment Methods for Rusting on FAG Bearing Outer Surfaces
Next: Differentiation of Adjustable Clearance Rolling Ball Bearings (Part 1)
Fixed Ball,Hard Sealed Ball,Hard Sealed Sphere,Hard Sealed Fixed Ball
Antong Valve Co.,Ltd , https://www.atvalveball.com